In other biochemical reactions, substrates require assistance of specific enzymes to form new products. When the amount of enzyme stays constant, the substrate concentration will determine the rate of reaction. However, when the number of substrate molecules exceeds the available number of enzyme, the rate of reaction will no longer increase, but stay constant. If there is a constant amount of enzyme, as the concentration of a substrate increased, the rate of reaction will increase as well. This is because of molecular collisions.
If you have more reactant molecules, there are more to collide. Aim: The effect of hydrogen peroxide on the enzyme activity of catalase Hypothesis: When the amount of enzyme stays constant, the substrate concentration will determine the rate of reaction CONTROLLED VARIABLES| Units| Possible effect(s) on results| Amount of enzyme | 2. 8g| an extra drop of enzyme can alter the rate of reaction | Size and type of test tubes | 30ml| The size and type of test tubes were constant, because they can alter the pressure | | Units| Range|
Obtain 3% hydrogen peroxide and a graduated cylinder. 5. Pour 5ml into test tube 1, 10ml into test tube 2, 15ml into test tube, 20ml into test tube 4, 25 ml into test tube 5, 30ml into test tube 6 (but not at once one after the another) . 6. Once hydrogen is in the test tube start the stop watch to see how long it will take to react. 7. Repeat the action in no. 5 & 6, six times for each tube. 8. Observe what happens to the liver while reacting to the hydrogen peroxide. 9. Clear up the station and pour liver into a waste beaker. 0. Clean each of the test tubes out and put the materials away. The materials used in this experiment are: I. 50-ml graduated cylinder II. Fresh liver III. 6 test tubes (30 ml) IV. 3% Hydrogen peroxide V. Disposable Pipettes VI. Stopwatch VII. Digital scale VIII. 50ml beaker IX. Test tube rack X. Plastic knife XI. Scissors QUALITATIVE DATA. The reaction started as soon as Catalase touched the surface of hydrogen peroxide. More concentrated hydrogen peroxide produced more oxygen bubbles and the reaction rate was faster.
As more substrate was added the reaction was faster. Once the 5ml of hydrogen peroxide was put into the test tube with the liver, the reaction rate was slow. As the amount of hydrogen peroxide increased the reaction became faster. When putting the 15ml of peroxide into the test tube 3 during the first trial the reaction bubbles spilled into tube 4 affecting the result slightly, because it made it to start reacting before the 20ml of peroxide was put into test tube 4 . In test tube 6 during the first trial the liver was lifted from the surface about 2cm.
My prediction was correct the more substrate was added the less time it used to react hence a faster reaction rate. There were no anomalous results. The data in this experiment suggests that the change in amount of substrate creates a faster reaction rate. EVALUATING PROCEDURES: Even though the experiment and the outcome of the experiment support my hypothesis; there are some weakness in this experiment that would have enabled a better outcome. The weaknesses that were present in the in the method of chosen for this investigation was the size of liver.
The last weakness the arrangement in the steps taken. To improve the results of this investigation is the size of liver should have been smaller, so that more reaction would have taken place and the color of the liver would have changed more for all of the tubes. Another improvement would be in the arrangement of steps taken. To avoid the spillover of the reaction bubbles into test tube 4, the amount of hydrogen peroxide should have been in the test tubes first then the liver should have been dropped in after.